Heavy Duty Electric Sludge Pump

The advantages of Heavy Duty Electric Sludge Pump

The product has the characteristics of reasonable structure, reliable operation and long service life. Especially suitable for medium and high concentration, strong abrasive conditions.

2. Low operating cost

The inner lining is cemented carbide or rubber with good wear resistance, corrosion resistance and high reliability.

3. Can be connected in multiple stages

The outlet direction of the Electric Sludge Pump can be rotated and installed at 8 angles to adapt to different on-site installation conditions.

How to solve the unstable flow of Heavy Duty Electric Sludge Pump?

The reasons for the unstable flow of the Heavy Duty Electric Sludge Pump are roughly as follows:

1. The suction pipe or bottom valve is leaking, or the water inlet is blocked, which is a common cause of insufficient flow. It is necessary to check the air leakage source of the suction pipe and the bottom valve and block it in time, or clean up the sludge or blockage at the water inlet.

2. If the voltage is too low, the speed of the slurry pump is reduced, resulting in insufficient flow of the Electric Sludge Pump. At this time, the power supply voltage should be checked and adjusted in time.

3. There is air leakage in the pipeline or there is air in the pump body. At this time, the air in the pipeline can be discharged in time.

4. Serious wear of the seal ring or impeller will also lead to unstable flow of the Electric Sludge Pump. The severely worn seal ring and impeller should be checked and replaced in time.

5. The depth of the bottom valve entering the water is insufficient, resulting in air entering during pumping. The depth of the bottom valve should be adjusted according to the suction stroke of the Electric Sludge Pump.

Want to know more about pump or need our Electric Sludge Pump, please feel free to contact our professional engineer below, we will provide best solutions~!

Phone/WA: +86 150 7520 7025

Email: leo@deponpump.com